Debug mode.

[Jeremy McSpadden]

Are you sure its not a taint issue? What distro? Can you paste bin any logs that show the loops?

--
Jeremy McSpadden
Flux Labs, Inc
http://www.fluxlabs.net<http://www.fluxlabs.net/>
Endless Solutions
Office : 850-588-4626
Cell : 850-890-2543
Fax : 850-254-2955

From: Ian McDonald <iam at st-andrews.ac.uk<mailto:iam at st-andrews.ac.uk>>
Reply-To: MailScanner discussion <mailscanner at lists.mailscanner.info<mailto:mailscanner at lists.mailscanner.info>>
Date: Wed, 7 Mar 2012 17:07:26 +0000
To: MailScanner discussion <mailscanner at lists.mailscanner.info<mailto:mailscanner at lists.mailscanner.info>>
Subject: Debug mode.

Hi,

Is there a way to get mailscanner to run normally, and chuck all the debug information into the logs too? (I know this will have adverse effects on performance :) )

We’re trying to get to the bottom of an intermittent issue where mailscanner loops over a message that clamav detects as having a virus in (over and over) until it quarantines it, but can’t seem to recreate it when the system’s not under load. We’re running 4.84.3.1, perl 5.10.1, clamav 0.97.3.

Thanks

--
ian

The University of St Andrews is a charity registered in Scotland : No SC013532

-- MailScanner mailing list mailscanner at lists.mailscanner.info<mailto:mailscanner at lists.mailscanner.info> http://lists.mailscanner.info/mailman/listinfo/mailscanner Before posting, read http://wiki.mailscanner.info/posting Support MailScanner development - buy the book off the website!
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.mailscanner.info/pipermail/mailscanner/attachments/20120307/43bb8a17/attachment.html