AW: RBL checks when some mail is received via a relay

[Jeremy McSpadden]

If you have control of the domain, by not deliver directly instead if through the relay?

--
Jeremy McSpadden
Flux Labs, Inc
http://www.fluxlabs.net
Endless Solutions
Office : 850-588-4626
Cell : 850-890-2543
Fax : 850-254-2955


On Aug 5, 2011, at 8:50 AM, "Tim Cappell" <tc at sommersoft.de> wrote:

> Hi,
> 
> No the relay is not whitelisted. As far as I understand, Mailscanner only queries RBLs for the last relay server which in this case is not blacklisted in any RBL.
> To clarify my situation I'll try to visualize our current mail flow:
> 
> 1) Domain.old: Sender -> mx.old -> mx.new with Mailscanner
> 2) Domain.new: Sender -> mx.new with Mailscanner
> 
> The problem is with part 1) of this setup, because all RBL checks are performed against mx.old which is a "good" server.
> I would need a setup where Mailscanner uses "Read IP Address From Received Header = 2" for situation 1) and "Read IP Address From Received Header = no" for situation 2).
> I don't know if this is possible so I'm also looking for alternate suggestions.
> 
> Tim
> 
> 
> 
> Von: mailscanner-bounces at lists.mailscanner.info [mailto:mailscanner-bounces at lists.mailscanner.info] Im Auftrag von Martin Hepworth
> Gesendet: Donnerstag, 4. August 2011 19:57
> An: MailScanner discussion
> Betreff: Re: RBL checks when some mail is received via a relay
> 
> Why are the emails from this relay being trusted? Have you whitelisted it or something?
> 
> Martin
> 
> On Thursday, 4 August 2011, Tim Cappell <tc at sommersoft.de> wrote:
>> We have a Mailscanner setup where some of the mails (from an older domain) are received by a relay (which is not blacklisted). Mailscanner works fine for all the mails we receive directly but RBL checks do not apply to those mails sent via the relay (which is still about 50%). Thus there are a lot of spam mails that get through although the originating mail server is blacklisted.
>> 
>> Is there a way to apply a method similar to "Read IP Address From Received Header" _only_ to mails where the last hop is that specific relay server?
>> 
>>  
>> 
>> Best regards,
>> 
>>  
>> 
>> Tim Cappell
> 
> -- 
> -- 
> Martin Hepworth
> Oxford, UK
> -- 
> MailScanner mailing list
> mailscanner at lists.mailscanner.info
> http://lists.mailscanner.info/mailman/listinfo/mailscanner
> 
> Before posting, read http://wiki.mailscanner.info/posting
> 
> Support MailScanner development - buy the book off the website! 
>