Looking for a good test to see that MailScanner is calling SpamAssassin properly

[james.raines at heartland-ins.com]

 On 8/18/2010 10:59 AM, Stef Morrell wrote:
> James Raines wrote:  
>> I am trying to find a way to 
>> test (from command line) to see that MailScanner is calling 
>> my implementation of SpamAssassin. Is there a good way to do 
>> this or am I going about it the wrong way? Thank you.
> In MailScanner.conf set both 
>
> # Set Debug to "yes" to stop it running as a daemon and just process
> # one batch of messages and then exit.
> Debug = no
>
> # Do you want to debug SpamAssassin from within MailScanner?
> Debug SpamAssassin = no
>
> to yes and run a test batch.
>
> You'll be able to see the full output from a spamassassin lint, which
> should give you all the info you need for your test.
>
> Stef
> --
> MailScanner mailing list
> mailscanner at lists.mailscanner.info
> http://lists.mailscanner.info/mailman/listinfo/mailscanner
>
> Before posting, read http://wiki.mailscanner.info/posting
>
> Support MailScanner development - buy the book off the website!
>
Thanks. I just found the Troubleshooting MailScanner section in the
documentation as well.

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.