selecting message that should go into MailScanner
glenn.steen at gmail.com
Thu Feb 12 13:59:32 GMT 2009
2009/2/12 Alessandro Dentella <sandro at e-den.it>:
> On Thu, Feb 12, 2009 at 01:26:41PM +0100, Glenn Steen wrote:
>> 2009/2/12 Kai Schaetzl <maillists at conactive.com>:
>> > I think you should direct your question to a postfix list if you want to
>> > do this in postfix. If you want to exemt mail in MS from scanning you want
>> > to use
>> > Scan Messages = %rules-dir%/scan.messages.rules
>> > Kai
>> Actually.... SInce Hugo van der Koij has made a very successful
>> "selective postfix" setup, and posted it here... this list isn't a bad
>> choice:-). At least not when it comes to finding that solution.
>> Basically one would replace the header checks with a rather specific
>> access map instead... Lets see if I can find the reference...
>> Here you go http://hugo.vanderkooij.org/email/mailscanner.htm#HOLD
>> (and yes, this was addressed both to Alessandro and you Kai:-):-)
> ehm... sure, that's the link I reported in my original mail that I tried to
See my reply to Kai... I'm probably not fit to do much anything today...
> implement. I tried to follow it but I can't really get it working. I don't
> think that's fault of the recepe but I must be doing something silly so that
> no messages gets into the rule even if I use:
> /.*/ HOLD
> /^$/ HOLD
Where did you implement the map? "postconf -n"?
> I admit this is almost a postfix question but I thuoght this is interesting
> for this list and probably there is real knowledge on this subject here.
> Personally I don't like the idea of letting it into MailScanner. There's no
> point in Scanning 50.000 email in a newsletter not even just for
> phishing/virus: the're all the same!!!
Make the ruleset on "Scan Messages", perhaps? As suggested by Kai...
This would bypass all scanning.
> Thanks anyhow for the hints on the ruleset, I'll use that in the meanwhile.
email: glenn < dot > steen < at > gmail < dot > com
work: glenn < dot > steen < at > ap1 < dot > se
More information about the MailScanner