Perl Modules

[--[ UxBoD ]--]

I do not have the devel package installed, and I was able to install the SA/Clam package from Jules with no problems at all.  Just installed the Dag RPMs and away I went.

Regards,

-- 
--[ UxBoD ]--
// PGP Key: "curl -s http://www.splatnix.net/uxbod.asc | gpg --import"
// Fingerprint: F57A 0CBD DD19 79E9 1FCC A612 CB36 D89D 2C5A 3A84
// Keyserver: www.keyserver.net Key-ID: 0x2C5A3A84
// Phone: +44 845 869 2749 SIP Phone: uxbod at sip.splatnix.net

----- "Ronny T. Lampert" <telecaadmin at gmail.com> wrote:

>>> So where does clamav-config come from?
>>
>> Only in clamav-devel or similar.
>>
> That's not mentioned as being something to install on the Wiki.  Should 
> I add it anyway?

I think - problem found.
Please install the clamav-devel.

[ The thing is, if you do a source install, all headers and libs and the 
clamav-config will be installed; when you do a rpm install, those are 
split and available in the -devel rpm only! ]

Report back!

Cheers,
Ronny
-- 
MailScanner mailing list
mailscanner at lists.mailscanner.info
http://lists.mailscanner.info/mailman/listinfo/mailscanner

Before posting, read http://wiki.mailscanner.info/posting

Support MailScanner development - buy the book off the website! 

-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.



-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.