Port

[Steve Douglas]

I looked at my config.pm file and syntax in line 1322 is as follows:

#
#Handle YesNo Values
#
sub ProcessYesNo {

The above is line 1322
SD
:-)


> -----Original Message-----
> From: Steve Douglas [mailto:steve.douglas at SBIINCORPORATED.COM]
> Sent: Tuesday, June 17, 2003 9:33 AM
> To: MAILSCANNER at JISCMAIL.AC.UK
> Subject: Re: Port
>
> Julian,
> I have the debug on still and I am receiving the following at the console.
> Starting MailScanner...
> In Debugging mode, not forking...
> Syntax error in line 550, value "" for warnsenders is not one of allowed
> values "yes","no" at /usr/lib/MailScanner/MailScanner/Config.pm line 1322
>
> I will refer to the config.pm file.  I discovered two places in the
> advanced
> section of the conf file that provides debugging.  I turned the second one
> on and the is what I receive.
>
> Steve Freegard: thanks for the valuable information.  I will look at this.
>
> I appreciate your assessments.  I am just chasing my tail at the moment.
>
> SD
> :-)
>
> > -----Original Message-----
> > From: Julian Field [mailto:mailscanner at ECS.SOTON.AC.UK]
> > Sent: Tuesday, June 17, 2003 5:11 AM
> > To: MAILSCANNER at JISCMAIL.AC.UK
> > Subject: Re: Port
> >
> > At 08:01 17/06/2003, you wrote:
> >
> > >Due to a total failure and McAfee blowing up last week I rebuilt my
> > >gateway again over the weekend.  I have RedHat v9, installed all the
> perl
> > >modules recommended by the MailScanner Quick Install notes, and
> installed
> > >the "rpm" of MailScanner.  I have completely turned the IP tables
> > >off.  When ever I audit the gateway, I show the correct ports open for
> > >other services.  However, I am unable to show port 25 for nothing.  My
> > >mailsend is configured with forwarding to my private email server under
> > >applicable domain names.
> > >
> > >
> > >
> > >Am I missing something?  I have done everything by the book, but am
> > >missing something here.  If I perform a netstat -top and nothing shows
> up
> > >in the way of MailScanner nor sendmail.  Something is deadly wrong.  .
> > >
> > >
> > >
> > >When I issue the "check_mailscanner (with debug activated) I receive
> the
> > >following:
> > >
> > >
> > >
> > >Starting MailScanner...
> > >
> > >In Debugging mode,  not forking...
> > >
> > >
> > >
> > >Any advice is appreciated.  Thanks
> >
> > With "Debug = no", what happens when you
> >          service MailScanner start
> > ?
> > --
> > Julian Field
> > www.MailScanner.info
> > MailScanner thanks transtec Computers for their support