Still battling with V4 and RaQ

[Gavin Nelmes-Crocker]

of course your right mqueue -> ../../home/spool/mqueue been working on
stuff all day and starting to get tired and not think

> -----Original Message-----
> From: MailScanner mailing list
> [mailto:MAILSCANNER at JISCMAIL.AC.UK] On Behalf Of Mike Kercher
> Sent: 26 October 2002 22:21
> To: MAILSCANNER at JISCMAIL.AC.UK
> Subject: Re: Still battling with V4 and RaQ
>
>
> RAQ's have symlinks all over the place.  Make sure your
> /var/spool/mqueue and /var/spool/mqueue.in ARE on the same
> filesystem and not symlinks.  If they are symlinks, move one
> or the other to the same filesystem to replace a symlink.
>
> -----Original Message-----
> From: MailScanner mailing list
> [mailto:MAILSCANNER at JISCMAIL.AC.UK] On Behalf > Of Gavin
Nelmes-Crocker
> Sent: Saturday, October 26, 2002 4:13 PM
> To: MAILSCANNER at JISCMAIL.AC.UK
> Subject: Still battling with V4 and RaQ
>
>
> ok well I tried a different approach this time by upgrading
> to 5.6.1 and then installing still some symlinking but not too bad.
>
> Now I'm trying to get it actually work - it starts up ok but
> the mail wasn't being processed so thinking this was tweaking
> required in the conf file I played about now I think I have it right
>
> #
> Incoming Queue Dir = /var/spool/mqueue.in
>
> # Set location of outgoing mail queue.
> # This can also be the filename of a ruleset.
> Outgoing Queue Dir = /var/spool/mqueue/q1
>
> but then I get this error
>
> [root MailScanner]# /var/spool/mqueue.in &
> /var/spool/mqueue/q1 must be on the same
> filesystem/partition! at /usr/sbin/MailScanner line 555
>
> as far as I can see both of them are on the same
> filesystem/partition am I being stupid? or just missing
> something basic I seem to have taken 3 steps forward on the
> install but several back on getting it running before I had
> it scanning but sendmail didn't deliver.
>
> Regards
>
> Gavin
>