MailScanner debug hanging

[Robert Lopez]

On Thu, May 16, 2013 at 12:21 PM, Robert Lopez <rlopezcnm at gmail.com> wrote:
> On Thu, May 16, 2013 at 10:28 AM, John Baker <johnnyb at marlboro.edu> wrote:
>> Hi, I'm finishing a new mailserver build with the last stable MailScanner. I
>> ran MailScanner --debug to check for problems and it keeps hanging after
>> Building a message batch to scan...
>>
>> However MailScanner --lint works ok.
>>
>> How can I get debug information on why debug won't run properly? Any
>> suggestions for sorting this out?
>>
>> --
>> John Baker
>> Network Administrator
>> Marlboro College
>> Phone: 451-7551 Cell: 490-0066
>>
>> --
>> MailScanner mailing list
>> mailscanner at lists.mailscanner.info
>> http://lists.mailscanner.info/mailman/listinfo/mailscanner
>>
>> Before posting, read http://wiki.mailscanner.info/posting
>>
>> Support MailScanner development - buy the book off the website!
>>
>
> run it again with --lint.
>
> These will sit and wait for a batch:
> MailScanner --debug
> MailScanner --debug --debug-sa
>
> These will not wait for a batch:
> MailScanner --debug --lint
> MailScanner --debug --debug-sa --lint
>
> There is strace as in:
> strace MailScanner --debug
>
> --
> Robert Lopez
> Unix Systems Administrator
> Central New Mexico Community College (CNM)
> 525 Buena Vista SE
> Albuquerque, New Mexico 87106

I think I must take back the running of lint with debug.
I just double checked that and all that really runs is the lint.

--
Robert Lopez
Unix Systems Administrator
Central New Mexico Community College (CNM)
525 Buena Vista SE
Albuquerque, New Mexico 87106