Mailscanner warnings

[AlxFrag]

Martin.Hepworth wrote:
>
>
>   
>> -----Original Message-----
>> From: mailscanner-bounces at lists.mailscanner.info [mailto:mailscanner-
>> bounces at lists.mailscanner.info] On Behalf Of AlxFrag
>> Sent: 15 February 2008 11:12
>> To: MailScanner discussion
>> Subject: Re: Mailscanner warnings
>>
>> Martin.Hepworth wrote:
>>
>> 	Ah there you go..
>>
>> 	Change the Virus Scanners to
>>
>> 	Virus Scanners = clamd
>>
>> 	And make sure the clamd settings are sensible further down the file.
>>
>> 	--
>> 	Martin Hepworth
>> 	Snr Systems Administrator
>> 	Solid State Logic
>> 	Tel: +44 (0)1865 842300
>>
>>
>>
>> 		-----Original Message-----
>> 		From: mailscanner-bounces at lists.mailscanner.info
>> [mailto:mailscanner-
>> 		bounces at lists.mailscanner.info] On Behalf Of AlxFrag
>> 		Sent: 15 February 2008 10:43
>> 		To: MailScanner discussion
>> 		Subject: Re: Mailscanner warnings
>>
>> 		--[ UxBoD ]-- wrote:
>>
>>
>> 			would you please run the MailScanner --lint
>>
>> 			it will either be in /usr/sbin or /usr/local/bin and
>> both should be in
>>
>>
>> 		your path anyway.
>>
>>
>> 			Regards,
>>
>>
>>
>>
>> 		Read 817 hostnames from the phishing whitelist
>> 		MailScanner setting GID to  (1002)
>> 		MailScanner setting UID to  (1004)
>>
>> 		Checking for SpamAssassin errors (if you use it)...
>> 		Using SpamAssassin results cache
>> 		Connected to SpamAssassin cache database
>> 		config: SpamAssassin failed to parse line, "/usr/bin/pyzor" is
>> not valid
>> 		for "pyzor_path", skipping: pyzor_path /usr/bin/pyzor
>> 		bayes: cannot open bayes databases
>> /etc/MailScanner/bayes/bayes_* R/O:
>> 		tie failed: Permission denied
>> 		bayes: cannot open bayes databases
>> /etc/MailScanner/bayes/bayes_* R/O:
>> 		tie failed: Permission denied
>> 		bayes: cannot open bayes databases
>> /etc/MailScanner/bayes/bayes_* R/O:
>> 		tie failed: Permission denied
>> 		SpamAssassin reported an error.
>> 		Using locktype = flock
>> 		MailScanner.conf says "Virus Scanners = clamav"
>> 		Found these virus scanners installed: clamav
>>
>> 		--
>> 		MailScanner mailing list
>> 		mailscanner at lists.mailscanner.info
>>
>>
>>
>> This gives the error:
>>
>> Feb 15 12:58:25 hermes MailScanner[6535]: Virus scanner "clamd" not found
>> in virus.scanners.conf file. Please check your spelling in "Virus Scanners
>> =" line of MailScanner.conf
>>
>>
>> It must be clamd running because in etc/local/clamd.conf i have:
>>
>> LocalSocket /tmp/clamd
>>
>> Also, if i type ps -A i get:
>>
>> 2319 ?        00:36:32 clamd
>>
>> Regards
>>
>>
>>
>>     
>
> Hmm looks there's a problem with the install then. Is this a fresh install or upgrade from an earlier version, as the clamd info in virus.scanners.conf has been present for quite a few releases now.
>
> --
> Martin Hepworth
> Snr Systems Administrator
> Solid State Logic
> Tel: +44 (0)1865 842300
>
>
>
>
> **********************************************************************
> Confidentiality : This e-mail and any attachments are intended for the 
> addressee only and may be confidential. If they come to you in error 
> you must take no action based on them, nor must you copy or show them 
> to anyone. Please advise the sender by replying to this e-mail 
> immediately and then delete the original from your computer.
> Opinion : Any opinions expressed in this e-mail are entirely those of 
> the author and unless specifically stated to the contrary, are not 
> necessarily those of the author's employer.
> Security Warning : Internet e-mail is not necessarily a secure 
> communications medium and can be subject to data corruption. We advise 
> that you consider this fact when e-mailing us. 
> Viruses : We have taken steps to ensure that this e-mail and any 
> attachments are free from known viruses but in keeping with good 
> computing practice, you should ensure that they are virus free.
>
> Red Lion 49 Ltd T/A Solid State Logic
> Registered as a limited company in England and Wales 
> (Company No:5362730)
> Registered Office: 25 Spring Hill Road, Begbroke, Oxford OX5 1RU, 
> United Kingdom
> **********************************************************************
>
>   
it's fresh install.

I have two machines running Mailscanner. The first uses the version 
4.57.6 while the second one uses 4.66.5.
Both show the warnings in the log file.



-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.mailscanner.info/pipermail/mailscanner/attachments/20080215/9d4a44a0/attachment.html