OT- Urgent question about Exchange relaying to MS

[Steven Andrews]

Just start and stop the service; not restart the whole box.  Yes,
anytime you make a change to the smtp virutal you should stop,
start...only way to be sure (well, that and nuking from orbit). 

-----Original Message-----
From: mailscanner-bounces at lists.mailscanner.info
[mailto:mailscanner-bounces at lists.mailscanner.info] On Behalf Of Glenn
Steen
Sent: Thursday, September 13, 2007 2:23 PM
To: MailScanner discussion
Subject: Re: OT- Urgent question about Exchange relaying to MS

On 13/09/2007, Steven Andrews <sandrews at andrewscompanies.com> wrote:
> On the exchange box, go to Exchange System Manager drill down to 
> Servers, Protocols, SMTP, Default SMTP Virutal Server, right click, 
> properties.  Delivery tab, advanced.  Put your defender in the "smart 
> host" box.  You'll have to use it's FQDN, not just IP (you can setup a

> defender.domain.local if you need on the domain's DNS server).  Click 
> OK to save it all.  Right click on the virtual server, stop it, right 
> click, start it.
>
> Done.
>
> The link you supplied below assumes smtp mail was never setup on the 
> box; I'm assuming it is.
>
> Steve

Don't think you need the restart... Then again, last I did that, was on
a 2k3 box (the M-Sexchanged admin was on vacation... Grmbl...:).
Other than that, it sounds about right. Browse about in the admin tool,
it ain't that complex:-):-).

Cheers
--
-- Glenn
email: glenn < dot > steen < at > gmail < dot > com
work: glenn < dot > steen < at > ap1 < dot > se
--
MailScanner mailing list
mailscanner at lists.mailscanner.info
http://lists.mailscanner.info/mailman/listinfo/mailscanner

Before posting, read http://wiki.mailscanner.info/posting

Support MailScanner development - buy the book off the website!