RES: mcp help

[Lasantha Marian]

Dear Julian,

I have been experiencing some strange behaviors in my MCP setup (SA
3.2.0/MS 4.59.4) too, i.e. MCP setup works very fine when tested from
command line so does SpamAssassin setup (from both ends; command line
and from MailScanner), but MCP would not work properly from MailScanner.
It would happily scan but does not report against customized MCP rules.
MCP rules are properly applied and correct scores are shown when run
from command line without any errors. The very same MCP rules set works
fine with earlier versions (SA 3.1.1/MS 4.53.8).

I think it is the same kind of problem that Wilson is experiencing in
MCP. It identifies MCP, but then may be a reporting problem !

Thanks and regards,

Lasantha.


*-------- Original Message --------*
*Subject: *    RES: mcp help
*Date: *    Tue, 29/May/2007 4:39:25 AM +0550
*From: *    "Wilson A. Galafassi Jr." <wilson.galafassi at gmail.com>
*To: *    "'MailScanner discussion'" <mailscanner at lists.mailscanner.info>


> spamassassin --D --lint > /tmp/sa.log 2>&1
>
> This is the result.
>
> [root at netserver tmp]# cat sa.log
> [26391] dbg: logger: adding facilities: all
> [26391] dbg: logger: logging level is DBG
> [26391] dbg: generic: SpamAssassin version 3.2.0
> [26391] dbg: config: score set 0 chosen.
> [26391] dbg: util: running in taint mode? yes
> [26391] dbg: util: taint mode: deleting unsafe environment variables,
> resetting PATH




-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.mailscanner.info/pipermail/mailscanner/attachments/20070529/a212e761/attachment.html