ClamAV Module Core Dump

[Scott Silva]

Drew Marshall spake the following on 5/1/2007 1:56 PM:
> Hi all
> 
> Ok another challenge that I hope you can help with. I am running a
> FreeBSD 6 box that I have just upgraded to ClamAV 0.90.2 which was
> upgraded from the ports tree. Knowing there can be issues, I also forced
> an update (Which in effect recompiles) of the Clam perl module.
> Restarted MailScanner and ever since MS core dumps. I can run MS using
> ClamAV only but it makes quite a performance hit so I want to get t
> reinstalled ASAP.
> 
> Running in debug mode, I helpfully get:
> 
> root at mx1 /usr/local/etc/MailScanner # mailscanner --debug
> In Debugging mode, not forking...
> Segmentation fault
> 
> /var/log/messages gets:
> 
> May  1 20:34:14 mx1 kernel: pid 43095 (perl5.8.8), uid 0: exited on
> signal 11 (core dumped)
> 
> Again no clues that I can see. Can any one give me some ideas where to
> start with this?
I have a similar issue in Centos 4. While I am not getting cores, MailScanner
will not run with the 0.20 module and 0.90.2 on one of my servers. It runs
fine with the commandline scanner, and I haven't had the time to upgrade to
the new version of MailScanner to test the clamd functionality. I get nothing
in debug, either.

-- 

MailScanner is like deodorant...
You hope everybody uses it, and
you notice quickly if they don't!!!!